Articles / 5 min read
Bio-coal in Pakistan: what the crop residue pellets are and how a mill should trial them
Bio-coal in Pakistan, as most mills will meet it, means pellets made by roasting cotton stalks and sugarcane waste, from a UK-funded plant being set up at the University of Kamalia in South Punjab. It is not on sale yet, three textile producers have only signed letters to test it, and the 40 to 50% saving its developers mention has not been shown in a Pakistani boiler. Below is what the pellets are, what heat to expect against Duki coal, and how to run a trial that gives you a usable answer.

Bio-coal in Pakistan: what the Kamalia plant will make
The project is called SAFER PLUS. Northumbria University announced on 11 August 2026 that it had won nearly £1.25 million from Innovate UK's Energy Catalyst Round 11, working with the University of Kamalia and a company called Eco Research. The plant uses torrefaction: crop waste is heated without much air until it turns dark and brittle, then pressed into pellets. The same reactor gives off gas for electricity, spare heat, and wood vinegar sold to farmers as a pesticide.
The waste will be gathered by a women-led cooperative from more than 120 households around the campus. The News carried the story on 17 August, and none of the reports gives an opening date for the plant.
| Item | What was reported |
|---|---|
| Feedstock | Cotton stalks and sugarcane waste |
| Process | Torrefaction, then pelleting |
| Site | University of Kamalia campus, South Punjab |
| Crop waste in | About 5,000 tonnes a year |
| Bio-coal out | Up to 4,000 tonnes a year |
| Buyers lined up | Three textile manufacturers, letters of commitment to trial |
| Plan after the trial | 30 hubs, said to displace over 100,000 tonnes of imported coal a year |
| Heat value | Not published |
Bio-coal heat value against Duki coal
No heat value for the Kamalia pellets has been published, so the nearest guide is laboratory work on the same crop.
A 2021 study in Biomass Conversion and Biorefinery torrefied cotton stalk and found its higher heating value rose from 16.88 to 22.21 MJ/kg. That is about 4,032 kcal/kg raw and 5,305 kcal/kg roasted, and the authors compared the roasted char to sub-bituminous coal. Duki lump is 6,000 kcal/kg typical on our sheet and Sor Range 6,500.
Watch the basis when you compare. Our lab report from Lab Zrk dated 30 October 2026 (report C578), on one truck of local 0/50 coal, read 6,333 cal/g on a dry basis with 14.1% moisture. Put the water back and the same coal gives about 5,440 kcal/kg as received. A pellet figure quoted dry must be set against a coal figure quoted dry, or one side looks better than it is.
- Sor Range (sheet, typical)6,500 kcal/kg
- Lab Zrk truck, dry basis6,333 kcal/kg
- Duki lump (sheet, typical)6,000 kcal/kg
- Lab Zrk truck, as received5,440 kcal/kg
- Torrefied cotton stalk (2021 study)5,305 kcal/kg
- Raw cotton stalk (2021 study)4,032 kcal/kg
The cotton stalk figures are from one laboratory study, not from the Kamalia plant. Sheet values are typical and their basis differs from a lab report.

The claims that are still unproven
The developers say the pellets could replace imported coal in brick kilns and textile boilers at 40 to 50% lower cost, with no change to existing equipment. Both points are estimates. No trial result has been published, and the comparison is with imported coal, not with the local coal most Punjab mills burn.
TEXtalks listed what will decide it: delivered fuel cost, heat value, emissions, ash behaviour, boiler efficiency, seasonal feedstock and reliable supply. Its view was that mill trials, not laboratory results, will settle whether the model can grow.
You can work out the price that matters today. If the pellets reach the study's 5,305 kcal/kg, they give the same heat for the money as delivered Duki lump at Rs 51,750 a tonne when they cost about Rs 45,754 a tonne delivered (51,750 × 5,305 ÷ 6,000). Against Sor Range at Rs 52,250, the figure is about Rs 42,642. Ask for a pellet quote delivered to your gate and set it against those numbers before you look at any percentage.
How much bio-coal there would be
Up to 4,000 tonnes a year is about 160 trucks of 25 tonnes, or around 333 tonnes a month from the one plant. Run that through the boiler coal consumption calculator with your own steam load to see what share of one mill it could cover.
The 30 hub plan is a roadmap, not a build schedule. Northumbria's release gives no dates for it, and the supply of cotton stalks follows the harvest, so a mill relying on pellets would need to know how much the plant stores for the months between crops.
How a mill should trial bio-coal beside coal
A trial is worth doing if you set it up so the result stands on its own. Run it on one boiler, against coal you already know, for long enough to see a full week of normal load.
- Get a written analysis of the pellet lot: gross heat value, moisture, ash, volatile matter and sulphur, with the basis stated.
- Have the same lab test a sample of your current coal, so both figures sit on the same basis.
- Weigh every load in and record steam or production for each shift, a week on coal then a week on pellets at the same load.
- Watch ash: how much comes out, whether it fuses on the grate, and how often the fireman has to clean.
- Check the bunker and feeder. Pellets that break up in handling turn to dust, which feeds and burns differently.
- Ask how the pellets should be stored in the rain, and test a bag left in your yard for a week.
- Price the result per unit of steam, not per tonne of fuel.
Questions people ask
Can a Punjab brick kiln burn bio-coal pellets?
Crop residue is not on the Smog Rules list of banned kiln fuels, but no biomass fuel has been approved for kilns either, so get a written reply from your district EPA office first. Our article on whether brick kilns can use biomass in Punjab sets out the rules.
Prices are indicative, per tonne, excluding sales tax, and change week to week. See today's sheet or ask us for a confirmed price.


