Coal merchants, QuettaDelivering to Punjab and Karachi

اردو
0349 4384514Get a quote

Articles / 3 min read

Coal for foundries and steel mills in Punjab: what works

Mineral coal belongs in the reheating furnace of a re-rolling mill and in some forging hearths. It does not belong in a cupola, which runs on coke, or in an induction furnace, which runs on electricity.

A tall chimney giving off thick dark smoke
Fig. 1A tall chimney giving off thick dark smoke. Stock photo

Which furnace takes which fuel

In a re-rolling mill, billets or scrap pieces are heated until soft enough to roll into rebar, angle, flat and round bars, and many smaller mills fire the reheating furnace with coal. A study of Lahore's re-rolling sector for the International Growth Centre describes most units as using non-electric furnaces that rely heavily on dirty fuels. Coal also fires some forging hearths, heat treatment furnaces and small crucible furnaces for brass and aluminium. In each case it heats the metal from outside.

Furnace and usual fuel
FurnaceUsual fuelMineral coal?
Re-rolling mill reheating furnaceCoal, furnace oil or gasYes, lump or graded coal
Forging hearthCoal, coke or gasYes, small lump
Heat treatment furnaceGas, oil, coal or electricitySometimes
Small crucible furnace (brass, aluminium)Coal, coke, oil or gasSometimes, sized lump
Cupola for cast ironFoundry cokeNo
Induction furnaceElectricityNot used
General trade practice, not a standard. Your furnace maker knows what yours was built for.

Why a cupola runs on coke

In a cupola the fuel sits in a column with the iron and limestone stacked on top, so it must carry that weight without crushing and burn without caking into a sticky mass. Foundry coke does. Raw mineral coal softens, smokes and gives off its volatile matter before it reaches melting heat. A cupola owner needs coke, not our coal.

The Punjab Smog Rules 2023 list hard coke among substandard fuels. Ask your district EPA office in writing what that covers for your coke.

Flames inside the firing mouth of a small kiln
Fig. 2Flames inside the firing mouth of a small kiln. Stock photo

Coal for a reheating furnace

A reheating furnace wants high, steady heat and little ash, because ash fuses into clinker on the grate, blocks the air and has to be raked out, and every raking is time the furnace is below full heat. Sor Range (6,500 kcal/kg, 9% ash) and Chamalang lump (6,300 kcal/kg, 11% ash) are the two we suggest. Duki lump at 15% ash is cheaper and many mills burn it, but a grade that costs less per tonne can cost more once raking labour and lost heats are counted.

A furnace is tuned to its coal: the air, feed rate and raking settle around one grade. If you want to try another, run it a full week on one furnace and write down the heats and the clinker raked per shift before deciding. Hand fired grates want lump or graded nuts, since dust falls through or smothers the bed and makes the black smoke an inspector looks for first. For a stoker or pulverised burner the maker's size range comes first.

Coal grades for a furnace (delivered Punjab, indicative)
Gradekcal/kgAsh %Sulphur %Rs a tonneRs per million kcal of coal
Sor Range6,5009352,2508,038
Chamalang lump6,300114.553,0008,413
Duki lump6,000154.551,7508,625
Duki run-of-mine5,50020547,0008,545
Mach / Harnai5,80020645,5007,845
Coal fines5,00025538,0007,600
Rs per million kcal = Rs a tonne x 1,000 / kcal per kg, heat in the coal before furnace losses. Clinker, raking and lost heats are not in it.

Sulphur and the metal

Balochistan coal carries more sulphur than most imported coal, 3% in Sor Range and up to 6% in Mach / Harnai. Where flame and gases touch hot steel, sulphur can be picked up at the surface and adds to scale, and it corrodes furnace steel and ducting. For ordinary bars that is usually managed. If your own buyer tests for sulphur, take the lowest sulphur coal you can get, keep the flame off the stock, and ask for the lab analysis of every lot. Tell us how the furnace is fed, the size range its maker gives and any sulphur limit your buyer sets, and we can say whether our coal fits.

Smoke checks on furnaces

Furnaces and re-rolling mills have been under smog season pressure for years. Dawn reported in November 2016 that 55 of the 337 furnace and re-rolling units in Lahore district were sealed in five days, some because their scrubbers did not work, with action in Gujranwala and Sheikhupura too. This season's inspection numbers are in the article on biomass in Punjab kilns. Sized coal, working scrubbers and bills that match the fuel in the yard are the defence.

A small forge burning a few sacks a week does better buying from a coal dealer near it. Our minimum is one truck of 25 tonnes. Chamalang lump is about Rs 53,000 a tonne and Sor Range about Rs 52,250 delivered in Punjab, indicative and confirmed when you contact us. Sindh coal is also available for buyers who want to compare; ask for the analysis and price.

Prices are indicative, per tonne, excluding sales tax, and change week to week. See today's sheet or ask us for a confirmed price.

GradesIn this guide

Grades mentioned

Dark, shiny pieces of coal, close-up

Higher-grade lump for kilns and cement blending

Chamalang coal

Origin
Chamalang, Loralai–Kohlu, Balochistan
Heat value
5,800–6,800 kcal
Size
Lump
For
Brick kilns, cement (blended)

FromRs 40,000per tonne, ex-yard

A heap of coal pieces, close-up

The cleaner local coal, for boilers

Sor Range coal

Origin
Sor Range and Degari, Quetta
Heat value
6,000–7,000 kcal
Size
Lump or mixed
For
Textile and industrial boilers, brick kilns

FromRs 39,250per tonne, ex-yard

Lumps of black coal, close-up

Balochistan's most traded coal, lump or run-of-mine

Duki coal

Origin
Duki, Loralai, Balochistan
Heat value
5,500–6,500 kcal
Size
Lump or mixed
For
Brick kilns, small industry

FromRs 34,000per tonne, ex-yard

QuotationToday's price

Get a confirmed price.

Tell us what you need. We send you a written price within 2 working hours.

You sendCoal, tonnes, city
We replyWritten price in 2 h
We deliverKarachi and Punjab in 2–3 days
A loaded haul truck on a mine road
Coal
Tonnes

Written price within 2 working hours.

Private. Your number is only used to send your price.

Prefer WhatsApp? 0349 4384514

Delivery and guidesAll cities

Keep reading, or get coal delivered.