Articles / 5 min read
Coal for rice mill dryers and parboiling: steam per tonne of paddy, husk and grade
Coal for a rice mill pays when the mill's own husk will not cover its parboiling and drying, which happens to a mill that sells husk or dries more paddy mechanically. A published estimate puts the fuel at about 200 kg of husk per tonne of paddy processed, close to all the husk that tonne yields, and the same heat comes from about 103 kg of Sor Range coal. Burn coal only in a boiler or an indirect dryer, never where its smoke touches the grain, and pick the lowest sulphur grade.

Punjab's rice belt and the drying season
Dawn reported on 31 October 2026 that crop burning in Punjab was concentrated in the rice-growing belt around Lahore.
Stubble fires come after the harvest, and they were still running in mid-November: in the 24 hours to 14 November the EPA dashboard showed 430 farm fires in Hafizabad, 172 in Sheikhupura, 70 in Kasur and one in Gujranwala, so paddy is still coming off the fields into the mills.
That paddy arrives wet. A Dawn article of July 2024 said farmers often cut at 20 to 30% moisture, that paddy should be dried to a safe 14 to 15% within 24 hours of harvest, and that over 90% of millers still sun dry, which rarely gets there. The writers called for mechanical dryers fired by rice husk. Every mill that adds a dryer adds a fuel bill for the months it mills.
Steam needed for parboiling a tonne of paddy
The International Rice Research Institute gives the steam for parboiling one tonne of paddy in a modern plant as 120 kg for soaking, 60 kg for steaming and 20 kg for losses: 200 kg in all, at 4 to 5 kg/cm2. It says a 6-tonne batch takes 20 to 30 minutes to steam, so a boiler serving that vessel must deliver about 1,200 kg of steam per batch, besides the soaking water.
Drying takes more heat than the steam does. A 2014 review of energy use in rice mills, citing Arora, gives 72,000 kcal for soaking, 21,000 kcal for steaming and 137,000 kcal for drying with air at 80 °C, about 230,000 kcal per tonne of paddy for the full parboiling job. That is heat delivered to the paddy; the fuel burned is more, depending on the boiler.
- Soaking72,000 kcal
- Steaming21,000 kcal
- Drying with hot air137,000 kcal
Arora (1982), as cited by Goyal, Jogdand and Agrawal, Journal of Food Science and Technology, 2014.

How rice husk and coal fit together
The same review puts husk at about 20% of paddy, or 200 kg a tonne, at an average 3,000 kcal/kg. It also cites 200 kg of husk, 2,800 MJ, to process one tonne of paddy in a husk-fired boiler at 45% efficiency. A parboiling mill with a dryer can therefore burn nearly all the husk it makes.
That leaves two ways a mill ends up buying coal. It sells husk because a buyer pays well for it, or its own husk runs short in the weeks it mills hardest. Either way, at 3,000 kcal/kg against 6,500 for Sor Range, each kilo of husk is replaced by about 0.46 kg of coal. Whether selling husk and buying coal comes out ahead depends on the husk price you are offered; our comparison of firewood, rice husk and coal costs both on heat.
| Coal | kcal/kg | kg per tonne of paddy | Rs per tonne of paddy, delivered Lahore | Paddy covered by one 25 t truck, tonnes |
|---|---|---|---|---|
| Sor Range | 6,500 | 103 | 5,376 | 243 |
| Chamalang lump | 6,300 | 106 | 5,626 | 236 |
| Duki lump | 6,000 | 111 | 5,768 | 224 |
Dryers: keep coal smoke away from the grain
FAO's guide to grain drying divides heaters into direct ones, where fuel burns in the drying air itself, and indirect ones, where a heat exchanger warms clean air. It warns that direct firing can lower grain quality through contamination with combustion products, lists coal, wood and biomass among the solid fuels used, and says an indirect heater can lose as much as 25% of its heat in the exchanger.
A 2024 study in Food Science and Biotechnology dried rice in a direct-fired dryer burning firewood and found nine PAHs, a family of combustion compounds, in the grain. Parboiled grains carried more, and wetter firewood made it worse. We found no such study for coal, so keep coal smoke out of the drying air altogether.
So coal belongs under a steam boiler, or in the furnace of an indirect dryer with sound exchanger tubes. In both, sulphur goes up the stack rather than into the grain, but it still matters for the plant and for the smog season inspections now under way in Punjab. Sor Range carries 3% sulphur as typical on our sheet, the lowest of our grades; one truck of local coal tested by Lab Zrk on 30 October 2026, size 0/50, read 1.89% on a dry basis. That is one truck, so ask for the analysis of yours.
Choosing grade and size for a rice mill
Sor Range is the grade for a food plant: lowest ash and sulphur on the sheet, at 6,500 kcal/kg, sold as lump 50 to 150 mm or mixed 0 to 100 mm. Tell us your grate and how you feed it, and we will match the size. Duki lump carries 4.5% sulphur as typical, so we would keep it to boilers well away from the grain.
If your boiler was built for husk, feed coal in as a share of the husk first rather than switching outright, and check what top size the grate takes. The boiler coal consumption calculator turns your steam load into tonnes a day, and our guide to the best coal for boilers covers grates and sizes in more detail. Delivered to Lahore, Sor Range is Rs 52,250 a tonne this week: Rs 39,250 at Quetta plus Rs 13,000 freight.
- Tonnes of paddy you parboil or dry a day, and for how many weeks.
- Boiler type, grate and the fuel it was built for.
- How much husk you burn and how much you sell.
- Whether your dryer is fired directly or through a heat exchanger.
Questions people ask
Is gas an option for a rice mill dryer this winter?
Industry gets gas only as supply allows. ProPakistani reported on 22 October 2026 that industrial users would receive gas according to availability this winter, with cuts to industry possible in a severe shortage, so plan the drying season on a fuel you can stock.
Prices are indicative, per tonne, excluding sales tax, and change week to week. See today's sheet or ask us for a confirmed price.


